471655 A New Thin Layered Structural Coating on a Metal Substrate for Enhanced Hydrogen Production from Steam Methane Reforming

Thursday, November 17, 2016: 9:50 AM
Franciscan B (Hilton San Francisco Union Square)
Michael Lugo, Department of Chemical Engineering, City College, City University on New York, New York, NY, Marco J. Castaldi, Department of Chemical Engineering, City College of New York, New York, NY, Dean Modroukas, Innoveering LLC, Ronkonkoma, NY, Andrew W. Davis, Alloy Surfaces Co. Inc. (ASC), Garnet Valley, PA, Rajinder Gill, Alloy Surfaces, Boothwyn, PA, Florent Minette, Materials and Process Engineering (IMAP), Universite catholique de Louvain (UCL), Louvain-la-Neuve, Belgium and Juray De Wilde, Materials and Process Engineering (IMAP), Université Catholique de Louvain (UCL), Louvain-la-Neuve, Belgium

The recent increase in the availability of hydrocarbons, especially methane, from shale gas exploration has led to renewed interest in converting or upgrading methane to higher value chemicals. Steam reforming is still the most developed and widely practiced industrial process for converting methane to hydrogen/syngas and its derivatives. It has no oxygen requirement and the most favorable H2/CO ratio for methanol and ammonia production of all available technologies. However, opportunities still remain to lower the energy requirement of steam reforming, including development of more efficient catalyst systems in terms of higher activity and effectiveness factors. Recently, Alloy Surfaces Co. Inc. developed an intrinsically bound thin-layered skeletal catalyst adhered on a metal substrate. These structures having relatively uniform coating thickness allow the physical manipulation into a highly active complex monolith structure that greatly enhances the catalyst effectiveness and interfacial heat and mass transport without applying an intermediate washcoat. A collaboration among City University of New York, City College, Alloy Surfaces, Co. Inc., Innoveering, and Université catholique de Louvain has been established to develop novel catalyst systems to more efficiently convert methane. Recently the team studied and analyzed this catalyst developed for hydrogen generation via steam methane reforming. Results have demonstrated that this catalyst is intrinsically more active than the conventional Ni catalyst and shows an increased selectivity toward CO2 and H2 and higher WGS rates. Methane-to-steam ratios ranging from 2.0 to 6.0 were tested over a temperature range between 400°C to 900°C at pressures of 1.0, 1.5, 3.0 bar with GHSV from 50,000 to 350,000 h-1. Mass balances were closed to within 2% and methane conversions were maintained below 20% of the potential equilibrium conversions possible at the particular test conditions. Results demonstrate the catalyst is capable of producing H2/CO ratios up to 425 from a reactant steam to carbon ratio of 3 at 515oC with no measureable change in activity over the time tested. The WGS reaction is about an order of magnitude faster than on the conventional nickel catalyst with nearly a factor of 2 enhancement of the CH4 + 2 H2O = CO2 + 4 H2 reaction. This presentation will show the results obtained over a wide range of conditions. A kinetic model with rate parameters was derived from the experiments with a specially designed microreactor and used to quantify the enhance selectivity toward hydrogen and carbon dioxide under typical commercial operating conditions. Finally some details will be given on how the enhanced performance is achieved.

Extended Abstract: File Not Uploaded
See more of this Session: Catalytic Hydrogen Generation
See more of this Group/Topical: Catalysis and Reaction Engineering Division