378938 Humidity-Dependent Compression-Induced Glass Transition of the Air-Water Interfacial Monolayers of Poly(D,L-lactic acid-ran-glycolic acid) (PLGA)

Tuesday, November 18, 2014: 9:30 AM
International 10 (Marriott Marquis Atlanta)
Hyun Chang Kim and You-Yeon Won, School of Chemical Engineering, Purdue University, West Lafayette, IN

Constant rate compression isotherms of the air-water interfacial monolayers of poly(D,L-lactic acid-ran-glycolic acid) (PLGA) show a distinct feature of having an exponential increase in surface pressure in the high surface polymer concentration regime. We have previously demonstrated that this abrupt upturn in surface pressure is linked to the glass transition of the monolayer, but the detailed mechanism of this process had not been fully understood. In order to obtain molecular-level understanding of this behavior, we performed extensive characterizations of the surface mechanical, structural and rheological properties of PLGA monolayers at the air-water interface, using combined experimental techniques including the Langmuir film balance, X-ray reflectivity and double-wall-ring interfacial rheometry methods. We observed that the mechanical and structural responses of the PLGA monolayer are significantly dependent upon the rate of monolayer compression; the glass transition was induced in the monolayer only at fast compression rates. Surprisingly, we found that this deformation rate dependence is also dependent upon the humidity of the environment. With water acting as a plasticizer for the PLGA material, the diffusion of water molecules through the PLGA monolayer appears to be the key factor determining the glass transformation property and thus the mechanical response of the PLGA film against lateral compression. Based on our combined results, we hypothesize the following mechanism for the compression-induced glass transformation of the PLGA monolayer; (1) initially, a humidified/non-glassy monolayer is formed in the full surface-coverage region (where the surface pressure shows a plateau) during compression; (2) further compression leads to the collapse of the PLGA chains and the formation of new surfaces on the air side of the monolayer, and this newly formed top layer of the PLGA film is transiently glassy in character because the water evaporation rate in the top surface region is momentarily faster than the humidification rate (due to the initial roughness of the newly formed surface); (3) after some period of time, the top layer itself becomes humidified through diffusion of water from the subphase, and thus it becomes non-glassy, leading to the relaxation of the applied compressive stress.

Extended Abstract: File Not Uploaded
See more of this Session: Nanostructured Polymer Films
See more of this Group/Topical: Materials Engineering and Sciences Division