Synthesis of Bifunctional Catalyst for Aqueous Phase Reforming of Biomass

Tuesday, October 18, 2011: 2:10 PM
207 A/B (Minneapolis Convention Center)
Richa Tungal1, Rajesh Shende2, Carlos Landaverde Alvarado2 and Kenneth M. Benjamin3, (1)Chemical and Biological Engineering, South Dakota School of Mines & Technology, Rapid City, SD, (2)Chemical and Biological Engineering, South Dakota School of Mines and Technology, Rapid City, SD, (3)Cbe, South Dakota School of Mines and Technology, Rapid City, SD

This study reports the synthesis of novel bifunctional catalytic material and its utilization in catalytic aqueous phase reforming of biomass to enhance selectivity and conversion into hydrogen and higher hydrocarbons. The synthesis involved the preparation of mesoporous aluminosilicate catalyst by using the surfactant assisted sol-gel method followed by immobilization of Ni/Cu/Ru.  The alkoxides precursors for aluminoslicate were chosen in a desired weight ratio and mixed with the Pluronic 123 surfactant. After hydrolysis and condensation steps, the gel obtained was aged for 24 h, treated in ethanol at 60oC for 2 hrs and finally calcined at 400-600oC at a heating rate of 1oC/min. The mesoporous structure was analyzed using TEM and the phase composition was determined using powder X-ray diffraction. The mesoporous aluminosilicate material was contacted with ethanol/water solution of  Ni and Cu salts for 8 h at 40-50oC. The powder obtained was dried at 105oC for 2 h and reduced under H2 environment for 2 h and further characterized by SEM/EDX to determine the loading of metal ions on the mesoporous aluminosilicate material. As received biomass (pine wood and cellulose) were subjected to aqueous phase liquefaction process at 250oC in a high pressure reactor in presence of homogeneous Ni or Cu salts as catalyst  and H2 generation was monitored. The slurry obtained after liquefaction process was processed further to recover the residue and bio-oil. The Ni/Cu loaded meosporous catalyst was contacted with the processed slurry obtained after liquefaction and the H2 and higher hydrocarbon formation was investigated. The results obtained on H2 generation during catalytic liquid phase liquefaction processing of a biomass, SEM/EDX analysis of Ni/Cu loaded aluminosilicate, and selective conversion into higher hydrocarbons will be presented.  In addition the mechanistic model based on catalytic free-radical chemistry will also be presented, and results discussed.

 


Extended Abstract: File Not Uploaded
See more of this Session: Renewable Hydrogen Production II
See more of this Group/Topical: International Congress on Energy 2011